Nah.

The concept of no-fault divorce must infuriate you.

Do thorns cause problems for screen readers for those with bision problems?

I wasn’t even given an option for sound, the guy told me the headphones were just for communicating. I just tanked 30 minutes in the tube with nothing but the sound of vibrations.

Yeah but this whole post is about resin prints, which cannot be acetone smoothed.

No, the reason clear 3d prints are cloudy is because layer lines cause scattering, which makes it appear cloudy. Coating the surface with a clear epoxy fills in the tiny gaps that causes light to scatter, improving the optical clarity.

Is the part in the middle not 3D printed? It says Formlabs Form 3.

Than 35? No, you’re not going to build a new printer from scratch for less than $35, especially if you don’t have another printer to print parts.

Buy a hotend, figure out what you did wrong previously, and fix your machine.

Ah, the perfect reminder that people on Lemmy can be just as big of dipshits as people on reddit were.

I mean, literally not? The meme about Don’t Dead Open Inside was that the words went top to bottom then left to right. This is the opposite. It reads left to right, top to bottom.

They probably bought it from someone who previously had rented it out.

Either the fees didn’t jump straight to $930 from $110 or the person didn’t do due diligence in reviewing the condo’s budget before they bought.

Can’t wait to see how the conservative majority on the supreme court bends over backwards to say their ruling that said Presidents can do anything they want doesn’t actually apply to the black one.

I’ve certainly never met a perscriptivist who I held in higher regard than Mark Twain.

Dude, that looks rough as hell compared to any resin print. I don’t get why some people just have to cope so hard over this, resin is just better for detail, it’s not a comment on your print skills or whatever.

God if this isn’t the truth.

One slight correction, nothing is stopping you from using Klipper with Octoprint. You just need to install the Octoklipper plug-in to Octoprint. Most people who run Klipper choose to use Mainsail or Fluidd, but it’s not required.