Pre-targeted strikes

It does say entire box

Afaik the mad max future they refine their own fuel.

I tried 235-250° without much change. Even tried uping the flow rate to 1.2 in the preset.

This is the only attempt that did not just fail at like layer 10 or something. And it’s still bad.

Thanks. I’ll try this if the manufacturer preset turns out to not work

I dried it for 8 hours before printing

Bring it on.

😭

Does he have any requirements the recipients must fullfil?

TPU 85A from Azurefilm. I don’t thibk they sell it anymore though.

Which is what happens anyway since it’s not extruding right.

I found the profiles but they only have them for different bambulab printers. I assume I can use those though?

I never used dynamic flow calibration and don’t have an AMS. Should I just reduce the default preset speed then?

It does not ring the AI alarm for me.

Yep uploaded to the internet at least 15 years ago.

but nobody seems to claim fondue is fake cheese.

Afaik you make fondue from cheese. You put the different kinds of cheese in and melt them with some wine. That’s way closer to just melted cheese than whatever american cheese is

It’s not propaganda though. I agree they were hiding bidens mental decline. But the fact this old farts on death’s doorstep get to run the country is fucking tragic. Thank god I was not born in the US

But the sad thing is Yellowstone won’t pop.

Nuclear winter sure is one of the ways to combat global warming.

I was mostly just wondering which OS and how you have your pihole and jellyfin set up.

How do you have it setup though? I got a hp elitedesk 800 micro and wondering what way to set it up