This is the necessary cable. https://www.fs.com/de-en/products/30827.html

Thank you for this great service to the community.

This shit tried to install a theme in my galaxy. Miss need to remove it.

I want this sooooo bad.

I have two services that my main account has zero admin rights on: gitlab and nextcloud. Both have, potentially, sensitive data owned by others. I’ve put massive passwords and MFA on both of those admin accounts. I figure if someone somehow harvests the session data or passwords and cracks 2fa on my account, that’s the only one that will be affected.

Shut up and take my upvote.

Lemmings.

Truth social did it and so can you.

Pour que no dos?

It can be two things.

Set your language to undefined.

Would this stl happen to live on the laggy purple site?

Best case scenario. As optimistic as I am about Lemmy, Reddit have a massive history which is going to suck to lose when it inevitably implodes like a submarine visiting the Titanic.

Underextrusion. You probably have burnt filament clogging your nozzle. Get your nozzle to 80C, then set it to 150C and start pulling the filament back out as the temperature climbs. It’s called a cold pull and usually clears this sort of thing.

Set your initial builtplate temp to 70, and the builtplate temp to 55 for printing. At 70 the pla will hit glass transition, then when it cools to 55 the adherence will be very good.

If you want smooth walls, slow the speed to like 40mmps, and squish the layers down to 0.10 mm with a .4mm nozzle if you can.

Play with ironing for the top surface smoothing.

I don’t recommend reducing your cooling much with pla. Maybe down to like 50% at the lowest.

Edit: your nozzle and later height should be fine, I glossed over that. Bring the nozzle down to 200 or so.

DNS can take 4 to 24 hours to replicate out. Next time, you can adjust you hosts file temporarily to test while it does it’s thing.