acargitz@lemmy.ca to 3DPrinting@lemmy.worldEnglish · 1 day agoAny ideas what I did wrong here? What caused these blobs?lemmy.caimagemessage-square7fedilinkarrow-up125arrow-down11
arrow-up124arrow-down1imageAny ideas what I did wrong here? What caused these blobs?lemmy.caacargitz@lemmy.ca to 3DPrinting@lemmy.worldEnglish · 1 day agomessage-square7fedilink
minus-squareeinkorn@feddit.orglinkfedilinkEnglisharrow-up5·1 day agoMore info please. At least printer model and slicer software used. At first glance it looks like to nozzle is too far from the bed.
minus-squareacargitz@lemmy.caOPlinkfedilinkEnglisharrow-up3·23 hours agoElegoo Centauri Carbon, and I’m using Orca on Linux.
minus-squareeinkorn@feddit.orglinkfedilinkEnglisharrow-up2·23 hours agoHave you completed the calibration steps in Orca Slicer?
minus-squareacargitz@lemmy.caOPlinkfedilinkEnglisharrow-up2·23 hours agoNope, didn’t know I had to, I’ve had multiple prints succeed previously, but also clogs often enough to be annoying, so maybe that’s it. Thank you very much for the pointer, let’s hope it’s what was missing.
More info please. At least printer model and slicer software used.
At first glance it looks like to nozzle is too far from the bed.
Elegoo Centauri Carbon, and I’m using Orca on Linux.
Have you completed the calibration steps in Orca Slicer?
Nope, didn’t know I had to, I’ve had multiple prints succeed previously, but also clogs often enough to be annoying, so maybe that’s it. Thank you very much for the pointer, let’s hope it’s what was missing.