While removing the extruder on my Creality Hi to clear a jam I damaged the wire that connects the extruder board to the print board and I have NO IDEA where to purchase a replacement wire.
It’s a 3pin wire roughly 9cm long with 2 male ends where 1 is about 2mm wide and other about 5mm wide.
MUCH appreciate any advice on where to shop and what search terms to use for locating a replacement, ideally located in the US.
I don’t know, but my first search turns up this, which looks like the cable in question.
https://forum.creality.com/t/looking-for-hi-cable/42587
If that’s the right cable, it has gauge and connector data.
I think that’s the one! Mine even has the “D” printed on the white sleeve like that one has. Thank you!!
Creality Hi Series Filament/Cutter Sensor/X Limit Switch Wiring
SKU: 3103080144
https://store.dremc.com.au/en-us/products/creality-hi-series-filament-sensor-wiring?variant=46843602665641
This is the only online store I’ve found so far that carries it. Will wait for support email to reply to see if they’ll supply it.
This looks correct. Awesome find!