While removing the extruder on my Creality Hi to clear a jam I damaged the wire that connects the extruder board to the print board and I have NO IDEA where to purchase a replacement wire.
It’s a 3pin wire roughly 9cm long with 2 male ends where 1 is about 2mm wide and other about 5mm wide.
MUCH appreciate any advice on where to shop and what search terms to use for locating a replacement, ideally located in the US.
I think that’s the one! Mine even has the “D” printed on the white sleeve like that one has. Thank you!!
Creality Hi Series Filament/Cutter Sensor/X Limit Switch Wiring
SKU: 3103080144
https://store.dremc.com.au/en-us/products/creality-hi-series-filament-sensor-wiring?variant=46843602665641
This is the only online store I’ve found so far that carries it. Will wait for support email to reply to see if they’ll supply it.