Veena
You can also see other 3D models on my page.
Subscribe to me and don't miss the latest uploads.
For any questions feel free to send me a message or contact me via email: [email protected]
I’d start with superglue, also @[email protected] makes a very good point. Creating some aligned holes and pins would make the assembly much more exact. I did something like this when I edited this model to fit on my previous printer. Slice the model and while it’s aligned in whatever editor you are using, create a 3mm diameter pocket which goes 5mm deep in each side in three places, creating a triangle of pockets. Then print some pins which just fit those holes. This will ensure everything lines up nicely. Once printed and glued, you can use a filler putty like Bondo to fill any gaps. Then sand and paint.
How would I go about putting them together? With super glue?
I’d start with superglue, also @[email protected] makes a very good point. Creating some aligned holes and pins would make the assembly much more exact. I did something like this when I edited this model to fit on my previous printer. Slice the model and while it’s aligned in whatever editor you are using, create a 3mm diameter pocket which goes 5mm deep in each side in three places, creating a triangle of pockets. Then print some pins which just fit those holes. This will ensure everything lines up nicely. Once printed and glued, you can use a filler putty like Bondo to fill any gaps. Then sand and paint.
That, but I’d also probably put some pins in to make it exact
A heat gun to weld the filiament together. Superglue actually sucks at bonding a lot of filaments.
Works great for pla though.