Dead kennedys:

https://youtu.be/amTAIjhUjDk?si=qfjvkyGwlgFXoEqs

If you were like me, the crew and passengers were evacuated.

Cant wait for the Plainly Difficult videos on those

Greetings Professor Falken

We all know, in the end, it will be Taco Bell that wins the fast food wars.

I recently discovered catwithhardhats. My fav is big saw cat stating “ripping farts, breaking hearts.”

https://www.redbubble.com/people/catwithhardhat/shop?artistUserName=catwithhardhat&pageSize=100

See you in the third act :)

deleted by creator

I have been making parts for my FIL’s 61 Ranchero. I have made almost every gasket, the heating couplers, and dash knobs.

Ty. I was also wondering about the Ted/Black flag.

Dont thread on me

Bless the Backstroke of the West

I would reference a Print Defect guide, such as the following:

https://all3dp.com/1/common-3d-printing-problems-troubleshooting-3d-printer-issues/#section-fdm-3d-printing-problems-my-print-looks-bad

Perhaps the section for “Some Layers Are Missing”

The absence of material leads me to an under-extrusion, though that could be influenced by a few things.

Your reported temps are fine, looks like bed adhesion is ok. So if there is an absence, the plastic didnt make it there. You have to ask why. Is it a restriction (resistance in the movement of the filament), filament defect (water content), extruder issue (nozzle), cascading first layer issue (clogged nozzle/z-cal).

Wasnt this the start of Highlander 2?