Bambu A1 mini still operates on 1.04 firmware which does not include authorization “security feature”. Naturally, I want to avoid it.

I know I can meddle with router somehow, even if it does not have parental controls or other very clear option to leave it inside local network.

However I would prefer preventing update in some other way, if there is any. This little printer is quite portable and I sometimes bring it to other locations. Also, remote printing and monitoring are nice features, which would be a pity to lose.

What would you suggest, or maybe have done yourselves?

  • dudenas@slrpnk.netOP
    link
    fedilink
    English
    arrow-up
    3
    ·
    6 days ago

    So far what I found:

    My router has an option to block internet access by MAC address, which is even better than by IP.

    LAN mode works via wi-fi, so no cables or flash drives needed.

    Also Orca slicer is almost the same as Bambu studio, even supports printer’s camera. Feels even snappier without an account and integration with “store” or whatever that online stuff is called.

    Got more interested in trying out VPN now, so I probably could observe prints from a laptop in any location.

    Not as bad as I feared, not as good as it could be.

    • spitfire@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      5 days ago

      You could set up Tailscale on any device in your network and access it through that. That’s probably the easiest way to do it.

  • ragebutt@lemmy.dbzer0.com
    link
    fedilink
    English
    arrow-up
    2
    ·
    edit-2
    6 days ago

    Easy mode: don’t connect it to internet

    Slightly harder: add exceptions for bambus servers in your routers firewall so that requests to that domain are blocked

    Dependent on hardware that you own and less likely to exist on basic routers: create a virtual lan for your 3d printer that does not have internet access but has intranet access, allowing you to connect between computers but not to the web (my preferred solution)

  • schizo@forum.uncomfortable.business
    link
    fedilink
    English
    arrow-up
    0
    arrow-down
    1
    ·
    edit-2
    6 days ago

    Don’t let it connect to the wifi/internet?

    I mean, sure, you have to do the SD card shuffle, but it’ll guarantee you don’t end up having to deal with this.

    If you have a more advanced set of network hardware (which it doesn’t sound like you do) you could add a firewall rule to block traffic from the LAN IP of the printer, or for something like Unifi, simply block internet access entirely. But, even then, if you screw it up now or in the future, surprise software updates will happen.