I’m a huge fan of octoprint on raspberry pi. I’m not a huge fan of raspberry pi lately. I’ve heard of le potato and orange pi. Some searching shows that people have done it on both of those.

Does anyone have any experience running it on a small board computer other than raspi?

  • fuckwit_mcbumcrumble@lemmy.dbzer0.com
    link
    fedilink
    English
    arrow-up
    2
    ·
    3 months ago

    If you plan on doing a lot with the machine then yeah it does make sense to get something better than a Pi. But for just octoprint any Pi is plenty.

    SD cards are a couple dollars, the pi 3 and below will run on any usb power brick. The 4 and 5 will run on any not low power brick you have lying around, but even if you feel the need to buy one the official one is like $15, and you can reuse it for other things too. And you can always 3d print a case if that’s really a problem, but I just let my pis dangle there, or I put them back in their box.

    Also second hand pis exist too, if you’re really strapped for cash you can get a full pi, case, sd card, and power supply for about the price of just the pi new. During the pandemic when Pis weren’t in stock I got a full setup for a pi 3 + this bluetooth keyboard trackpad thingy for $30.

    • ExcessShiv@lemmy.dbzer0.com
      link
      fedilink
      English
      arrow-up
      3
      ·
      edit-2
      3 months ago

      But for 15$ more, you get an immensely more useful tool for when you (probably) inevitably want to do more/other things. SD cards for a few bucks burn out really quickly, so you’d really want a good one (significantly more expensive) or an SSD, bringing the total cost of a pi above a used NUC, with worse specs all around.

      I really can’t see the argument, neither financial, performance/watt or performance/$ for an SBC if you don’t need GPIOs.

      • fuckwit_mcbumcrumble@lemmy.dbzer0.com
        link
        fedilink
        English
        arrow-up
        1
        ·
        3 months ago

        (probably) inevitably

        That’s the key here, not everyone wants to do that. OP specifically asked for something to run octoprint, not an entire homelab. Not everyone is interested in that.