potatobro@lemmy.blahaj.zone to 3DPrinting@lemmy.worldEnglish · 4 hours agoStay safe folkslemmy.blahaj.zoneimagemessage-square23fedilinkarrow-up1255arrow-down11
arrow-up1254arrow-down1imageStay safe folkslemmy.blahaj.zonepotatobro@lemmy.blahaj.zone to 3DPrinting@lemmy.worldEnglish · 4 hours agomessage-square23fedilink
minus-squarelivligkinkajou@slrpnk.netlinkfedilinkEnglisharrow-up17·3 hours agoA1 model has multiple reports, I’m not sure about others yet
minus-squareOwl@mander.xyzlinkfedilinkEnglisharrow-up7·3 hours agoAnd only recent ones or older ones too? I luckily don’t own an A1, but if other models are affected I might never use them again
minus-squareSphks@jlai.lulinkfedilinkEnglisharrow-up6·edit-21 hour agoPre-2025 ones. I have to check mine :-(
minus-squareWIZARD POPE💫@lemmy.worldlinkfedilinkEnglisharrow-up4·1 hour agoWell fuck need to check mine then. Bought it used so I don’t know if it’s older than that
minus-squareSphks@jlai.lulinkfedilinkEnglisharrow-up3·edit-21 hour agoSeen elswhere : it seems that it’s due to high current with 110V. I am on 220V so it’s less prone to default. It’s the NTC component on the alimentation board. EDIT. No. The 220V is also prone to the issue :-(
A1 model has multiple reports, I’m not sure about others yet
And only recent ones or older ones too? I luckily don’t own an A1, but if other models are affected I might never use them again
Pre-2025 ones. I have to check mine :-(
Well fuck need to check mine then. Bought it used so I don’t know if it’s older than that
Seen elswhere : it seems that it’s due to high current with 110V. I am on 220V so it’s less prone to default.
It’s the NTC component on the alimentation board.
EDIT. No. The 220V is also prone to the issue :-(
Shit.