Started making these sounds in the middle of the print. It kept extruding though, didn’t stop or something. The stepper motor isn’t that old, but wasn’t expensive either. Anyone knows this sound?
Started making these sounds in the middle of the print. It kept extruding though, didn’t stop or something. The stepper motor isn’t that old, but wasn’t expensive either. Anyone knows this sound?
You sure you didn’t get an agitated cicada stuck in there?
Seriously, though. It could be the stepper or even just a cooling fan.
It’s no fan, I checked that. Also definitely comes from the extruder assembly, I could slightly manipulate it if I was pushing on the filament from above.
Then worn bearings on the extruder gears, or a gear chipped.