So I’ve decided to get “back” into 3d printing. I was getting into it in 2012 and I started assembling a kit, but then life happened and I never had enough time or room to complete it.
However, now I’m in a much better place (both literally and figuratively), so I’ve decided to dive back in. However, last time around it seemed that almost everything was some variant of Prusa, and I think I want to go in a less DYI direction this time.
- Once calibrated, doesn’t need much fidgeting or maintenance.
- More or less prefabricated. Some assembly is fine, but I don’t want to sit there an dremmel a hobbled bolt again, or build a power supply.
- I prefer one of those enclosed printers, as it will be in a location with minimal climate control.
- Must not rely on any software that does not run on linux
- I’m not too worried about printing speed. Print quality matters more to me.
- Preferably one that is fixable if it breaks.
- Single filament is fine.
- Don’t need wifi
Any suggestions?
Oh, and I still have a spool of ABS around here somewhere… Is this still a reasonable material choice? Any other materials worth considering if I prefer the prints to be durable and not brittle?
This is where I could list a budget or preferred price range, but purchasing power parity and exchange rates probably complicates this, so let’s just say “reasonably priced”
UPDATE: I ordered a Prusa Core One. I went for the kit, as I will hopefully better understand how I can fix it later after assembly. I threw in a spool of PETG as well, as I’m curious about the material.
You’re correct about all of this, but it’s way easier to press print than machine a part from stock. I do some machining as well (I don’t own the machines, but I’m trained on the mill, lathe, and waterjet in our shop). So most of the time if I can get away with a 3d printed part, it’s worth it for the time savings alone. Plus sometimes the easiest or optimal geometry to design is not something that can be machined, but can be printed.
It’s specific circumstances where the basic filaments fall short, like creep and heat resistance, irrespective of print parameters. ASA and PET-CF work well in most of these spots, so I don’t do anything more exotic.