Inland is good.

Ive not actually had a truely bad roll of PLA but I also don’t bargin hunt on Amazon.

I just watched a tutorial video. Once I figured out how sketching works a lot of other tasks became easier to figure out and intuit.

I do think knowledge is disorganized, said knowledge is out of date and a lot of included legacy workbenches are offered which adds to initial confusion and the errors aren’t very helpful.

I use the linktree branch though. Prior to learning freecad I also worked primarily in a codeCAD library in golang which probably helped with understanding basic operations.

If you look at the community its empty.

You could…just make a solid works community, there isn’t even a reason to be jerk about freecad you’re not obligated to use it.

As an extruder its fine, I will say cooling shrouds tend to be very bulky and the default cooling isn’t very good.

Def a cool controller. I remember reading about it awhile ago.

My project will use a conventional pcb, I just needed to test the spacing of the buttons and get a literal reference for how big it’ll be since I knew it was gonna be a bit chunky.