emiellr

This must be satire

Or Blender

For good bed adhesion I think I have a couple pieces of advice:

• Get a PEI bed if you don’t already have one. It makes a world of difference.
• If that doesn’t stick well, consider getting something like this
• Make damn sure your bed is level
• Make sure the Z offset is properly set up
• If you aren’t already, start by printing PLA, then move on to other filaments once that goes well.
• Make sure you have proper temperatures for both the hot end and the bed. Normal values for PLA are 210-230 on the hotend and 50-60 on the bed.