Nanomerce

I had this problem as well, though I fixed it by using a 3 knob bed rather than a 4 knob one.

I have like 2 USB chargers that are really loud.

OMG it’s little paws

last time I didn’t use self checkout, the cashier keyed in all my stuff as organic when it wasn’t :(

maybe the creality filaments are moist? Do you hear popping noises? if so then try drying em in a dehydrator.

Qimgv, Rawtherapee

shows up as pawb instance for me

I love synchronous mode for quickly adjusting parts. Otherwise the standard mode works pretty much the same as solid works with some quirks.

the ad center in your account would be where you would tweak what kind of ads you get.

It’s in data and privacy. https://myadcenter.google.com/home

For FDM, learning how to level your bed and set the z offset properly will save a lot of headache early on.

have you made sure your adjustment knobs are as tight as possible?

I found that if I tightened all my knobs to max I could, then leveled by loosening some and adjusting the z offset, it would stay there for much longer.

doesn’t have Linux support, but Solid Edge community let’s you save locally.

looks like it really depends, https://us.beasensors.com/en/segment/vehicle-sensing-solutions/barriers/ has some information about the specific sensora they use.

yeah temperature then flow calibration should solve over extrusion problems that will cause your parts to stick to each other or otherwise bind.

XMouseButtonControl is by far the best mouse macro software I have used (assuming you have no more than 2 side buttons)

Love polymaker for the natural filament.

omg the flufff

what are those little nubs on their head? I thought it was ears but I think I see those.

if only there were enough people using solid edge to have a community around it 😭

System Engineer, Chapter 36 page 10