Yep I did this and then ran out of time and sold the kit at a huge loss
Yep I did this and then ran out of time and sold the kit at a huge loss
Recently I went through some pain with this myself. Had a full Heatmiser setup with wireless receivers in every room and 2 manifold controllers for our underfloor heating on two floors.
The devices ate batteries like nothing I’ve seen before and regularly dropped off the network and didn’t send call to heat signals properly, so I decided to switch out the thermostats for cheap ZigBee temperature sensors.
I then ordered a relay board from AliExpress with a baked in esp8266 cheap and flashed esphome onto it. These replaced my manifold controllers
After trial and error, I now have my heating system run by esphome and home assistant. It has been faultless! Will probably reinstall the Heatmiser kit if I sold the house though
Yeah pretty much most bars and restaurants will use a mixer gun for providing soft drinks. It’s usually carbonated water and it will inject syrup for coke, pepsi, sprite etc at regular intervals. The syrup is just a box from the drink company that they have hooked up to pipes out back
Thanks for this reply! I put off the professional install of panels as the ROI was just too far out. Self install did come up as I’m fairly competent but your points still highlight the problems. Sometimes the numbers just don’t work, even if you can do it cheap
I’m too tired and thought that sign said “Life is Rob Lowe”
I use S3 sync via the cli and use lifecycle policies to manage number of snapshots and deletion.
Some cool options for moving files to different tiers like cold and glacier but I don’t know enough about it or the retrieval costs to use it just yet
Who else immediately blinked after the title?