It looks like the pumpkin body curves over and then down to the stem, so it would be a lot of filament swaps.

Honestly, I haven’t used Kodi in a lot of years. There are add-ons for things like Netflix and YouTube, and I vaguely recall using those.

I found this, for example: https://howtomediacenter.com/en/install-netflix-kodi-addon/

If you can get a UI set up, like Kodi or something, I liked using my Flirc receiver on my htpc. You can use any IR remote, and completely map the buttons to functions. It was sweet.

RatRig V-minion uses printed (ASA/PETG) parts for all motors, and 10k mm/s² acceleration is normal. Granted, a smaller bed slinger, but still.

The big one? That’s a coextrusion silk bicolor blue-green. I love the coloring, but it’s kinda a PITA about bed adhesion.

https://www.printables.com/model/209121-cali-dragon

https://www.printables.com/model/209121-cali-dragon

It’s a fun little filament test.