Well hopefully Susan will bring in some dictator shaped cupcakes at least.

For strength there are some decent GID PETG options. Glow for all these is pretty good with regards to intensity but poor for duration. Be ready to replace your brass nozzle a little sooner than you thought. Using a oxbidian nozzle and it seems to take the beating well.

We better at least get off for a national dictator day out of this whole debacle.

Be awkward by having a right hand but no right arm…

A little late, but yeah, der, obviously.

I printed a sunglass case sorta like this but way less engineered. Mine also has exposed magnets but curious if you considered embedding them into the print with just a couple bridging layers printed over them? I’ve seen magnet cases like this eventually have the magnet overcome the glue and pull out.

Not the demons? Was the demon that mauled him a liberal demon?

What are they doing on the days in between?

Yes. Advise against doing what I did which is getting weirdly agile with modeling in the slicer at the cost of making cad software less desirable to learn. I finder Tinker cad pretty limiting and personally I can do more in slicer than I can with tinkercad. I do like Mattercontrol which is free, easier to use, and more powerful than tinkercad.

Please don’t. Mitch is just as awful but with a tiny bit of intelligence making him dangerous.

He will ask for copy. He hasn’t seen her nude in years.

Uh huh. Did you start to believe the earth is round while you were up there too?

Interesting. If they weren’t patent trolls before, they certainly are now!

I wonder if this is all that’s stopping this technique though? IANAL, but it sure seems like a slicer could release this and if stratasys tried to sue them, they might have a hard time given all these patent errors.

Still profitable you say? Sounds like a slap on the wrist is due here and we let the exploitation continue!

So many rules!

It’s not hard

There is a difference to adding some more wood to a fire and placing jet fuel onto a fire.

Watch out. Luxotica going to place a hit on you.

My mental health is hurting. Such deep sadness. Really struggling to find good in this world.

Recommend this. Have a similar setup and you can 3d print spools and order bearings for them. That being said my direct drive filament feeder on my prusa is quite strong. As long as you make smooth curves with your bowden tube it should be ok.