• SzethFriendOfNimi@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    3
    ·
    6 months ago

    I was wondering about that. Considering with ABS a little acetone makes a stronger overall part.

    I was thinking maybe the dovetail would be good in that situation for strength but maybe something like a biscuit or peg and hole as mentioned is better?

    • mipadaitu@lemmy.world
      link
      fedilink
      English
      arrow-up
      6
      ·
      6 months ago

      I think the video is better as a way to show some design techniques, than as a demonstration of dovetails as a connector.

      That being said, if you didn’t need a permanent connection, it does seem like a decent way to make something that can come apart easily. Wondering how strong it would be after multiple assembles and disassembles.

      • nilloc@discuss.tchncs.de
        link
        fedilink
        English
        arrow-up
        2
        ·
        edit-2
        6 months ago

        I’ve done some dovetails for a puzzle design before. They were meant to assemble and disassemble in multiple orientations.

        Depending on the layer line directions the problem I had was getting the fit tight enough to not fall apart, but not too tight to remove. I abandoned it because the PLA absorbed water and they became stuck after sitting in humidity for a few days.