Any ideas as to what I’m doing wrong?

This sphere has a ridge on it, and I’ve had miniatures come out with the base to be slightly offset giving a bit of a ridge.

I’m using a Halot One, lychee Slicer, and Anycubic Water Wash resin.

  • Tarnaq@lemmy.worldOPEnglish
    10·
    2 years ago

    It may be because I paused the print to check raft adhesion. I’ll try some prints tomorrow without pausing.

      • Tarnaq@lemmy.worldOPEnglish
        3·
        2 years ago

        That’s what I’m beginning to suspect, other prints that have had ridges or offsets I paused as well.

    • AmieFromEarth@lemmy.worldEnglish
      2·
      2 years ago

      Im pretty sure that you have that issue cause of the pausing then. I paused a print once, during one of my first prints, and after resuming it failed. So i just made it a thing to never pause prints again. It just messes with the print for some reason.