Last year I said I'd probably never recommend another Bambu Lab printer again. I still use my P1S, but after Bambu Lab started pushing their always-connected cloud solution as the new default: I blocked the printer from the Internet via my OPNsense Firewall I stopped updating the firmware I locked the printer into Developer mode I deleted Bambu Studio and started using OrcaSlicer I had to do that to keep it under my control, instead of Bambu's.
  • sbeak@sopuli.xyzEnglish
    2·
    2 hours ago

    I have an A1 too, and when the news came out that third-party slicers (like OrcaSlicer, which I was and still am using) were going to be blocked, I set my printer to LAN only mode. I wouldn’t recommend a Bambu to newbies to 3D printing anymore, but I’m stuck with mine and it has been printing ok. Like any printer, it struggles with overhangs and such, it’s not always a magic “it just works” experience".