Sadly, almost is relative. The dimensions were off by say 1%, but over larger spans that’s 1-2mm.
I am not at all opposed to taking heat and/or tools to prints to massage them vs tossing the first go and printing fresh, but that wasn’t practical here :(
Bummer. Glad you had already considered it though. At one point in my 3D printing journey I would’ve gone straight back to CAD for small tolerance issues
Sadly, almost is relative. The dimensions were off by say 1%, but over larger spans that’s 1-2mm.
I am not at all opposed to taking heat and/or tools to prints to massage them vs tossing the first go and printing fresh, but that wasn’t practical here :(
Bummer. Glad you had already considered it though. At one point in my 3D printing journey I would’ve gone straight back to CAD for small tolerance issues