nieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 2 months agoWhat is the problem here?programming.devexternal-linkmessage-square27fedilinkarrow-up137arrow-down10
arrow-up137arrow-down1external-linkWhat is the problem here?programming.devnieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 2 months agomessage-square27fedilink
minus-squareThePantser@sh.itjust.workslinkfedilinkEnglisharrow-up25arrow-down1·edit-22 months agoToo close, level the bed and increase the Z offset until the smoosh is right. Also since it looks like it’s in different places you should do a probe calibration to adjust for uneven surface.
minus-squarespitfire@lemmy.worldlinkfedilinkEnglisharrow-up2·2 months agoAlso preheating and waiting before bed leveling helps. These beds are wobbly. I’ve put a glass bed on top of the factory one on my K1
minus-squareJoelk111@lemmy.worldlinkfedilinkEnglisharrow-up2arrow-down1·2 months agoIn some places it’s too close, but in many places (like the top) it’s way too far away.
minus-squareRichard Wonka@slrpnk.netlinkfedilinkEnglisharrow-up1·2 months agoIt may have a probe levelling grid active that’s out of whack.
Too close, level the bed and increase the Z offset until the smoosh is right.
Also since it looks like it’s in different places you should do a probe calibration to adjust for uneven surface.
Also preheating and waiting before bed leveling helps. These beds are wobbly. I’ve put a glass bed on top of the factory one on my K1
In some places it’s too close, but in many places (like the top) it’s way too far away.
It may have a probe levelling grid active that’s out of whack.