I’ve begun printing more minis for TTRPG, and since i only have a cheap bedslinger that’s what I’m using.

Normally I’ve just stuck with minis designed specifically for supportless FDM printing, but I wanted to try my hand at something else and went with this Minotaur

fresh from the printer, supports all over

supports removed front

supports removed back

There’s still a bit of post-processing before priming and painting, but I’m actually pretty happy with the quality, considering it was done on a $200 entry-level printer.

Printed in eSun PLA+ with a 0.2mm nozzle and 0.08mm layer height, it took just short of 9h to print it.

  • ExcessShiv@lemmy.dbzer0.comOPEnglish
    10·
    9 months ago

    goblin with sword and shield

    skeleton with halberd

    orc with bow

    I’m pretty happy with the goblin and skeleton, the orc’s bow is a little wonky at the top because my layer time was too short for my printers cooling. None of these has had any post processing done yet, printed without any supports also 0.2mm nozzle and 0.08mm layer height.

    I think I’ll try printing a sort of “buffer tower” next time to increase layer time on prints with pointy tips and see if it helps.

      • ExcessShiv@lemmy.dbzer0.comOPEnglish
        4·
        9 months ago

        I mean, they’re definitely good enough for me but resin does give much better fine details. But I also mainly use my printer for functional prints, this is just a nice addition to its uses.